TEST YOUR BLOCK KNOWLEDGE.
QUESTION (1) What is meant by the term dry sleeve?
ANSWER
QUESTION (2) What is meant by the term wet sleeve?
ANSWER
QUESTION (3) What are the two common materials blocks are made out of?
ANSWER
QUESTION (4) What properties of a cast-iron block are superior to an alloy block?
ANSWER
QUESTION (5) What properties of an alloy block are superior to a cast iron block?
ANSWER
QUESTION (6) What is the purpose of a stress plate when boring an engine?
ANSWER
QUESTION (7) What is the recommended amount of material left to hone out of a bore when boring and why?
ANSWER
QUESTION (8) What is a cross hatch pattern referring to?
ANSWER
QUESTION (9) What is unidirectional honing and what can it cause?
ANSWER
QUESTION (10) What is plateau honing?
ANSWER
QUESTION (11) What is a bottle brush or flex hone?
ANSWER
QUESTION (12) What is the preferred method of honing that reduces the ring bed -in period with current design rings?
ANSWER
QUESTION (13) What does line boring a block describe?
ANSWER
QUESTION (14) When surface grinding a block face what engine assembly procedure has to be considered?
ANSWER
90% to 100% correct answers indicate a good understanding of engine problems and functions. This web site is full of information that may improve your knowledge and skill.
: Every care has been taken in writing this information and procedures, but no responsibility can be excepted for errors, omissions or misuse of this information and procedures. The information available on this site is for your instruction only and cannot be copied for sale, © copyright 2001 UMR Engines www.engineproblem.com.au