TEST YOUR HONING KNOWLEDGE.
QUESTION (1) What is the purpose of honing a used bore that is being re-rung?
ANSWER
QUESTION (2) What is bore glazing?
ANSWER
QUESTION (3) What is bore polishing?
ANSWER
QUESTION (4) Why can't we run the new rings on the re-machined bore without honing?
ANSWER
QUESTION (5) How do we know if our hone pattern is ok?
ANSWER
QUESTION (6) What amount of material should be left for honing after boring?
ANSWER
QUESTION (7) What grit stones should I use?
ANSWER
90% to 100% correct answers indicate a good understanding of engine problems and functions. This web site is full of information that may improve your knowledge and skill.
: Every care has been taken in writing this information and procedures, but no responsibility can be excepted for errors, omissions or misuse of this information and procedures. The information available on this site is for your instruction only and cannot be copied for sale, © copyright 2001 UMR Engines www.engineproblem.com.au